Products Search


We install all of our products in house

FJ60 BJ60 HJ60 HJ61 FJ62 Axle Bearing Replacement Kit Full Float 1981, 1982, 1983, 1984, 1985, 1986, 1987, 1988, 1989, 1990


In stock

This kit includes axle bearings, gaskets and seals

Will only work with Full Float rear axles with factory differential lockers

Does both sides.

In stock

SKU: WBKL5C Categories: ,


At Man A Fre, we have a supply of Toyota Land Cruiser full floating rear axle assemblies.  For most situations, the semi-floating rear axles, as supplied for the US market, are just fine.  However, in the rest of the world, Toyota offered these heavy duty full floating rear axles for Land Cruisers that are used for towing and hauling heavy loads.

Why a full floater?

Very simply, the semi-floating rear differential, as found on all 40 and 60 series Land Cruisers sold in our market, use a rear axle that keeps the axles in place by holding them in with “C” clips in the differential unit.  The weight of the vehicle is supported by the axles which turn in a single roller bearing located at the outer end of the axle housing.

On a full floater there are no”C” clips holding the axles in, instead at the end of the axle hosing are spindles, similar to the ones on the front axle of the Land Cruiser.  These spindles support wheel hubs that have two tapered roller bearing in each hub.  The bearings are adjusted with a nut just like the front wheel bearings and the axles are held in or onto the hub with six studs, washers and nuts.  This system makes for a much stronger rear drive axle set up for those that need, or want, the extra load carrying potential.

Additional information

Weight 6 lbs
Dimensions 8 × 8 × 8 in

Go to Top